SPECIFICATIONS
FRAME:
UNDER GUIDE CAPACITY:
WHEELS:
 
TIRES:
GUIDES:
GUIDE POST:
 
 
BAND WIDTHS:
BLADE SPEEDS:
BAND DRIVE:
RAILS:
 
 
THROAT TABLE:
RECIRCULATING COOLANT
SYSTEM:
HYDRAULIC SYSTEM:
ELECTRICAL SPECS:
 
FEED TABLE:
 
BRIDGE CLAMPS:
 
 
AUTOMATIC COMPUTER:
CONTROLLED
INDEX SYSTEM
 
 
 
 
 
 

Heavy duty welded steel construction with 35 1/2" throat capacity
6" STD. (Other capacities available)
Two (2) 36" diameter super rigid all steel wheel with heavy duty shafts
and bearings
Tannewitz Speedi-change demountable tires with neoprene surface
All steel Tannewitz guides with carbide jaws. (1) Upper, (1) lower
Hydraulically operated with column mounted controls, automatically
maintains proper blade tension.  Capable of tensioning a 1 1/2" x .050
blade to 30,000 PSI
Minimum 1", Maximum 2"
Variable from 55 to 350 SFPM (or any other 6:1 ratio)
5 HP std.
Saw rides on hardened Thompson roundways, and has hydraulic feed
travel and rapid return of 150".  Feed Rate infinitely variable from .5
inches to 25 inches per minute
Has stock holding capacity of 24" (STD)
 
STD. Complete with pump
5 HP, 15 Gallon per minute hydraulic pump and reservoir to JIC spec.
To NMTBA Standards, with 115 volt push-button circuitry,
NEMA 12 enclosures.
Has the capability of holding a maximum piece of 6" x 40" wide x
144" long (12,000 lb.)
5 hydraulically actuated bridge clamps are standard for holding the
work piece in position
 
This systems consists of three (3) hydraulically actuated rear
clamps that does not release the plate during cutting or indexing.
This feature insures the accuracy of repetitive cuts.  The saw can
be programmed to make up to 99 cuts of various widths.  Saw will
cut continually while the programmed number of cuts is being
fulfilled.  Also included is an interrupt option that permits a special
cut to be made, and the saw automatically returns to the pre
programmed cutting sequence.  This programmable feature allows
the saw the cut on its own without operator attendance.