Tannewitz has just built a special saw for one of our customer's specific needs.
This Model G1NE has a 20hp motor and blade speed of 5,000 SFPM.
Other features include:
38" under guide capacity
Tannewitz R0418A precision guide assemblies
The oversized hydraulic table - 80" long x 72" wide can handle the largest
graphite blocks, 76" of table travel assure straight square rip cuts. A full
length cut off gauge positioned to the left of the blade allows for repetitive
The table also has a R.H. extension to accommodate longer pieces when cross
cutting, three full length T-slots allows the operator to position graphite or
fixtures in the optimum position.
Controls are pedestal mounted which allows the operator to position themselves
for clear view from any angle.
Call Dave or Kevin today if you have a special application you would like us to
Designed specifically for use with diamond blades, to provide accurate and
efficient sawing of the most difficult material (i.e. silicon, ceramic, quartz
Infinitely variable band speed 2800 to 6000 FPM digital readout
Hydraulic table with digital speed readout –speed range .01-6” IPM
Stainless steel guide system featuring special rear roller wheel designed with
air purge bearing to eliminate micro cracking of blade back
Non circulating coolant system with complete recovery system including splash
guard protector and stainless steel recovery pan
Table feed feature slow start beginning and end of cut to prevent chipping
Hydraulic blade tension
Hydraulic guide post adjustment